Recent Posts

| Forums | Topics

Topics with their latest replies in reversed order
	After the test is completed, assistance cannot be provided. By wangchu 1 week ago \| Last Post: 7 days ago Forum Microcontroller Firmware (C++)
	@zfl3 Thank you. We also encountered the same prob... 7 days ago By shanc... To clarify, you're using the latest software relea... 7 days ago By Zacha...
	After assembly, there is no power assistance. By wangchu 2 weeks ago \| Last Post: 1 week ago Forum GUI Software (Python)
	Headless mode means controller the device without ... 1 week ago By Zacha... Hello, regarding this open-source project, we asse... 2 weeks ago By wangc...
	i can not read SD_card.The debug output reads: "SD.begin() failed By huang_EnHong 2 weeks ago \| Last Post: 2 weeks ago Forum Microcontroller Firmware (C++)
	@huang_enhong Which version of the code are you us... 2 weeks ago By Zacha... We tested the hardware with the program 'CardInfo'... 2 weeks ago By huang... @huang_enhong Have you tried another SD card or Te... 2 weeks ago By Zacha...
	Connecting both the torque sensor and FSR to PCB By Delta 3 weeks ago \| Last Post: 2 weeks ago Forum Motors and Sensors
	Hi Delta, you could either use the 8-pin connector... 2 weeks ago By Zacha... We are making the right side ankle. Using the torq... 3 weeks ago By Delta
	MIT mode？ By wuyang 2 weeks ago \| Last Post: 2 weeks ago Forum Motors and Sensors
	the AK enable CAN message is built and sent in _CA... 2 weeks ago By Zacha... Hello, I’d like to confirm whether the motor is op... 2 weeks ago By wuyan...
	Ankle build cable crimps By delta 3 weeks ago \| Last Post: 3 weeks ago Forum Mechanical Parts
	Hello @delta Thank you for reaching out. You are... 3 weeks ago By Riley... I am following the ankle build guide, but I am stu... 3 weeks ago By delta
	Feedback regarding possible wiring errors on the PCB. By huang_EnHong 3 weeks ago \| Last Post: 3 weeks ago Forum PCB - Electrical
	Sorry for the confusion! The document was worded i... 3 weeks ago By Noah Dear Development Team,In Figure 1, gray and purple... 3 weeks ago By huang...
	New Ankle Build Guide Posted By OpenExo Team 4 weeks ago \| Last Post: 4 weeks ago Forum Announcements
	New Ankle Build Guide Posted 4 weeks ago By OpenE...
	software v2.0 By OpenExo Team 4 weeks ago \| Last Post: 4 weeks ago Forum Announcements
	See GitHub release for v2.0! 4 weeks ago By OpenE...